Device Setup
The setup menus can be accessed only when the device is turned on while pressing and holding the p button.
This mode can only be activated at device turn-on.
The operation is as follows:
|
1.
|
Press and hold the p button while turning the device on. |
|
2.
|
Use the p and q buttons to enter the setup password. The default password is "672". |
|
3.
|
Press  button to enter the setup menus. |
|
○
|
After two incorrect password entries, device enters Normal Operation mode. |
|
○
|
Correct password: device continues/beeps once. |
|
|
The password can be changed through the MSA GALAXY GX2 Test Stand or MSA Link software.
|
In the Setup mode:
|
•
|
Press the button to store chosen value or go to the next page. |
|
•
|
Press p button to increase values by one or toggle a selection on or off. |
|
•
|
Press and hold p button to increase values by 10. |
|
•
|
Press q button to decrease values by one or toggle a selection on or off. |
|
•
|
Press and hold q button to decrease values by 10. |
The following options are available by pressing the q and p buttons:
|
•
|
Sensor Setup (SENSOR SETUP) |
|
•
|
Calibration Setup (CAL SETUP) |
|
•
|
Alarm Setup (ALARM SETUP) |
|
•
|
Setup Time and Date (TIME DATE) |
|
•
|
Bluetooth Setup (BT SETUP) |