Spectacle Kit

WARNING! 

Before using a spectacle kit, an optometrist must examine the spectacle kit and prescribe the correct lenses to fit into the lens frame on the spectacle kit.

Failure to follow this warning can result in serious personal injury or death.

	1. Turn the head harness over the front of the facepiece so the harness covers the lens of the facepiece. This will open up the faceblank to make it easier to install the spectacle kit.
	2. Squeeze in on the wire frame of the spectacle kit at the large bends about 2 in. (5 cm) from the ends.
	3. Push the top part of the wire frame into the lens of the facepiece. The faceblank has three rubber tabs made to grab the wire frame.
	4. Push one end of the wire frame up into the facepiece so the frame is in position along the edge where the lens and faceblank meet.
	5. Make sure the end of the wire frame is in position in the small pockets in the faceblank on the edge of the lens. 6. Do Steps (4) and (5) on the opposite side.
	7. Don the facepiece. 8. Adjust the lens frame up/down and in/out to optimize fit and visibility.