Ordering Information
Replacement Parts
See Table 19 for replacement sensor kits. To obtain a replacement sensor, address the order or inquiry to:
General Monitors
16782 Von Karman Ave, Unit 14
Irvine, CA 92606
or call, toll-free, 1-800-446-4872.
Inquiries can also be e-mailed to info.gm@msasafety.com.
WARNING!
Use only genuine MSA replacement parts when performing any maintenance procedures provided in this manual. Failure to do so may seriously impair sensor and gas monitoring performance, alter flameproof/explosionproof characteristics or void agency approvals. Failure to follow this warning could cause the product to fail to perform as designed and persons who rely on this product for their safety could sustain serious personal injury or loss of life.
Repair or alteration of the S5000 Gas Monitor, beyond the scope of the maintenance procedures provided in this manual or by anyone other than authorized MSA service personnel, could cause the product to fail to perform as designed and persons who rely on this product for their safety could sustain serious personal injury or loss of life.
Failure to follow these warnings can result in serious personal injury or death.
|
Type |
Description |
P/N |
|
PCBA Assemblies |
S5000-PCB |
|
|
Sensor Body, XCell |
A-5K-SENS |
|
|
Sensors, XCell |
A-5K-SENS |
|
|
Sensor Guard, XCell |
Sensor Guard Assembly, S5000 |
10177624 |
|
Sensor Guard, ULTIMA XIR PLUS |
REPLACEMENT SENSOR GUARD FOR XIR PLUS SENSORS |
10184684 |
|
Sensor Guard, IR400 |
Sensor Guard, IR400, with Screen |
32545-1 |
|
Sensors, Passive |
CB 0-100% LEL (C04 – Screened, Div Approvals) CB 0-20% LEL (C10 – Sintered, Zone Approvals) CB 0-100% LEL (C11 – Sintered, Zone Approvals) |
10058-1 11159-8 11159-1 |
|
MOS 0-100ppm (M04 – Screened, Div Approvals) MOS 0-100ppm (M14 – Sintered, Zone Approvals) |
50448-1 51457-1 |
|
|
MOS 0-50ppm (M05 – Screened, Div Approvals) MOS 0-50ppm (M15 – Sintered, Zone Approvals) |
50448-5 51457-5 |
|
|
MOS 0-20ppm (M06 – Screened, Div Approvals) MOS 0-20ppm (M16 – Sintered, Zone Approvals) |
50448-9 51457-9 |
|
|
Sensor, IR4001 |
Methane, NFPA |
IR400-0-01-2-2-0-1-0 |
|
Propane, NFPA |
IR400-0-02-2-2-0-1-0 |
|
| Hexane, NFPA | IR400-0-04-2-2-0-1-0 | |
| Pentane, NFPA | IR400-0-05-2-2-0-1-0 | |
| Ethylene, NFPA | IR400-0-06-2-2-0-1-0 | |
| Butane, NFPA | IR400-0-07-2-2-0-1-0 | |
| Ethane, NFPA | IR400-0-08-2-2-0-1-0 | |
|
Methane, IECEx |
IR400-0-13-2-2-0-1-0 |
|
|
Propane, IECEx |
IR400-0-14-2-2-0-1-0 |
|
| Hexane, IECEx | IR400-0-15-2-2-0-1-0 | |
| Pentane, IECEx | IR400-0-16-2-2-0-1-0 | |
| Butane, IECEx | IR400-0-17-2-2-0-1-0 | |
| Ethane, IECEx | IR400-0-18-2-2-0-1-0 | |
| Ethylene, IECEx | IR400-0-22-2-2-0-1-0 | |
|
Duct Mount Kit |
Duct mount kit, rectangular |
10176947 |
|
Duct mount kit, round, small, (12"-20" / 305-508 mm diameter) |
10179124 |
|
|
Duct mount kit, round, large, (20"-40" / 508-1016 mm diameter) |
10179321 |
|
|
Calibration Kit (XCell) |
CALKIT1 CALKIT2 CALKIT3 CALKIT4 |
|
|
Pipe Mount Kit, Universal |
Pipe Mount, X5000/S5000 |
10176946 |
|
Junction Box |
Junction Box, SST, IIB + H2 Junction Box, SST, IIC |
324240-1 324240-3 |
| JB5000 Junction Box |
3/4" NPT M25 3/4" NPT FM Approved M25, FM Approved |
10213879 10213893 10213892 10213896 |
|
Calibration Cap, XCell |
Calibration Cap, X5000/S5000, packaged |
10181450 |
|
Calibration Cap, XIR PLUS |
CALIBRATION CAP, ULTIMA XIR PLUS, PCKGD |
10181461 |
|
Calibration Cap, IR400 |
Calibration Cap, IR400 packaged |
1400270-2 |
|
Sun Shield |
Sunshield, X5000/S5000 |
10180254 |
|
1- Only IR Sensor P/Ns shown can be used with the S5000. |
||
For position of labels, see Label Overview
The following accessories have been validated for use when installed in accordance with the instructions in this manual:
|
Accessory |
Validation Method |
| Calibration Kit | CSA & FM Approvals |
| Junction Box | CSA & FM Approvals |
| JB5000 Junction Box | CSA & FM Approvals |
| Calibration Cap (XCell, IR400) | CSA & FM Approvals |
| Wireless HART | CSA & FM Approvals |