Harness Attachment

WARNING! 

DO NOT rely on feel or sound to verify proper connector engagement. Ensure the connector is closed before use.

Failure to follow this warning can result in serious personal injury or death.

Attach V-TEC EDGE PFLs to Harness Using V-TEC EDGE Pin Connector

The V-TEC EDGE PFL pin connector allows connection to a full body harness just below the rear D-ring or through the PFL tunnel.

1. If harness has PFL tunnel—use PFL tunnel as connection point.

If harness does not have PFL tunnel—Lift D-ring on harness and pull straps through dorsal pad until V‑TEC EDGE pin connector can feed between webbing straps and dorsal pad.
2. Press the button on right side of the pin and press the button on the top of the right side of the bracket. Pull the pin to the right to open the pin connector.
3. With the button on the pin depressed, feed the pin through PFL tunnel or behind both straps on harness to the left side of the bracket.
a.   Release the button on the pin and pull on the end of the pin slightly to ensure it has locked into place.
4. If harness has PFL tunnel— Installation complete.

If harness does not have PFL tunnel— Pull harness straps back through dorsal pad to eliminate slack in webbing.